Part Time Conversion Kits

Search for Part Time Conversion Kits and related items in our webshop

These conversions improve fuel economy, reduce driveline backlash and reduces vehicle maintenance costs. It also enables the LOKKA automatic diff locker to be installed to the front differential.

Fuel Economy

Obviously there is a reduction in the load on the engine if the front section of the transfer case, the front tailshaft, differential, axles and wheels are not being 'driven'. This reduction in load translates to increased fuel economy.


Front axle seals, CV joints and the outer drive flanges wear heavily with constant use, resulting in expensive and needless repairs several times over during the life of the vehicle. The cost of overhauling the front differential housing once will be nearly twice the cost of the Part Time Conversion Kit.

Other major parts such as the front tailshaft, axle seal surfaces on the front axles and the front differential itself also wear but at a lesser rate than the other parts. These parts will require repair - at a much greater cost - but fortunately less often.


The existing driveline has multiple points of contact where 'backlash' or 'play' can occur. There are 3 differentials in the system with many splined couplings and flanges. The accumulation of all these points of backlash often result in the sloppy feel and clunky noises when rapidly changing throttle position or when changing gears.

Fitting of the Part Time Conversion Kit reduces the total amount of backlash by 80% in some cases. The vehicle has a much tighter feel and considerably smoother gear changes. Although less noticeable in automatic vehicles, the problem still exists. The steering is also noticeably lighter.


There is no centre differential after the conversion, the centre differential gears are removed. It is these gears that make the front drive parts move ALL the time. The conversion is performed to stop the front parts moving altogether.

After conversion, only the rear drives, until you use the differential lock mechanism/switch in the transfer case to engage the front shaft. The factory lock mechanism is not inside the centre/transfer case differential, it is right at the front of the transfer case and simply locks the front output shaft to the front half of the centre differential case.

Once 'locked' the front 'side gear' in the centre differential cannot turn, so all the other planetary gears are also fixed relative to the case and the two tail-shafts are effectively locked together. The Part Time Conversion Kit simply uses this existing mechanism to get drive through the centre differential case to the front tail-shaft, after conversion.

Saves between 14 - 16% fuel useage (according to almost everyone that has taken any notes and reported back to us), limits wear on all front end components - particularly the CV joints, boots and axle flanges, substantially reduces the drive line backlash most noticeable with rapid acceleration followed by deceleration or poor clutch pedal control on manual vehicles. Makes a much smoother more economical vehicle.

If you have large 4wd tyres or front differential locker, the HD hubs are the way to go. If its mainly a tow vehicle and not used much off-road, then standard hubs are fine.

A simple kit can be fitted to the Transfer Case in approximately 4 hours. No special service tools are required. A quality Free Wheel Hub set is included in the kit. There are comprehensive fitting instructions for the DIY owner.

Fitting of the Part Time Conversion Kit also provides the opportunity to fit the LOKKA automatic differential locker to be fitted to the front differential.

The alternative is to fit a manual differential locker. The cost of parts alone is far greater (locker, compressor, other fittings etc) plus fitting. Then you have the problems of air lines or wires under the vehicle, potential pressure loss inside the differential housing and limited steering when engaged - all associated with manual lockers.

With the Part Time Conversion you have all the advantages of the LOKKA Automatic Locker (for off-roading) with the benefits of the Part Time Conversion - virtually at no cost - as manual lockers are a much greater cost than the LOKKA) - which are 14-15% better fuel economy (according to almost everyone that has taken any notes and reported back to us), no wear and tear on front end components, smoother driveline. Fuel savings alone will cover the cost of conversion.

Our Lokka's are AUSTRALIAN made, they come with a 3 Year UNCONDITIONAL Warranty.
Comprehensive Fitting Instructions included. The differential gear set does not have to be re-set and the carrier bearings are not replaced, so its a pretty simple fit for the mechanically inclined.
Warranty is the same no matter who does the fitting.

Landcruiser 105 Series and 80 Series with ABS brakes

All GXL105 Series and a few 80 Series have ABS brakes, which uses sensors on the axle to monitor the system.

When the Part Time Conversion is fitted, the ABS will 'fault', as the axle with the inductor fitted stops rotating - the whole purpose of the conversion.

There are various ways of going around this, but one option is to fit a relocation kit - moves the existing sensors to a new location and new inductors are fitted to the hubs. (like the IFS 100 series).

Transfer Case parts Manufactured in Australia
3 Year Warranty - Unlimited Kms
1 Year Warranty - Unlimited Kms for FWHubs

Part Time Conversion Kits


Ian M of SA
80 Series

Just a few words about the Part Time 4WD Conversion you did on my 80Series Cruiser. Driveability has improved dramatically with no clunk in the drive train as you engage the clutch. My wife will now drive it!

Turning circle is better as there is no drive to take you in a wider arc. After not showing much in the way of better fuel consumption, I found I had an air-filter problem, I can see a marked improvement, both in towing a 2 tonne van and in normal work. Between 10-15%!

Bill H of SA
Toyota LCR HDJ100 2006, LCR HDJ80

Just want to thank you for the recent upgrade with the front Lokka and part time kit for my 2006 GXL 100 series Auto Turbo Landcruiser.

As with the 80 series which I had for 12 years and 600,000 kms I am pleased with the performance, fuel economy and reliability from the Lokka and part time kit.

With my work in the Petroleum Exploration, Heritage Surveys, and Pipeline Survey industries, often in very remote regions of SA, NT and QLD; I need to access all types of terrain mostly before any road construction. I travel a variety of conditions, many highway miles, outback tracks and off-road scouting (often where no tracks exist).

Vehicle reliability and capability are paramount, as I often travel single vehicle.

I realised the reduction in fuel consumption ( 15%) and expensive wear & tear in the front end with the 80 Series and can report the 100 series is giving me similar results.

I had the Lokka fitted to make off-road scouting possible in the remote locations I work. I am amazed at the change in the vehicles capability with the front Lokka installed. During off-road scouting I have been able to climb sand hills that other standard vehicles -100 Series, 70 Series troopie & ute – were unable to follow, even in my tracks.

I have no problems with engagement and steering. I only realise I have it engaged when I occasionally hear the Lokka unlocking.I am extremely happy with the decision to install both parts, having achieved my original aims and much more.

I replaced my 80 Series at 600,000kms, having travelled 420,000kms with the Lokka and Part Time Kits fitted for the last 8 years.

Now with a 2006 100 Series turbo diesel auto, I have fitted the Part Time Conversion and front Lokka, with the same result. Off road performance is astounding, even though it has torsion bar front suspension. I was dubious about its ability prior to in-field use, but I need not have worried.

I would like to reiterate how happy I am with the Lokka and Part Time Kits, both perform exactly as explained and extensive use has proved them to be extremely reliable.